User Manual

Appendix A ● IP-RN 8000 Specifications
194 Release 2.0, 910056 Rev01d
Table 31 Bell Core Earthquake Standards
Specification Description
Bell Core Zone 4 Installations procedures in this guide provide protection from earthquakes in the following
Bell Core seismic zones: Zone 1, Zone 2, Zone 3, and Zone 4.
Table 32
Connectors, screws, nuts, washers
RF cables Male N-type connector. Use 13/16 inch open ended wrench.
GPS cables
Male N-type connector. Use 13/16 inch open ended wrench.
Access panel screws
Tamper proof screw with rubber lock washer.
• Screw: button socket, 1/4-20 by 3/4 inch, stainless steel, with pin.
• Washer: lock washer, SLFSE, 1/4 inch
Tamper resistant
screw driver
5/32 inch tamper resistant hex driver
Access panel gasket
washer
RACO 1209 washer
Cabinet anchor bolts
• Bolt: stainless steel, 1/2-inch bolts rated as ASTM, F-593, condition C (minimum)
• Washer: stainless steel 1/2 inch flat washer
• Lock washer: stainless steel 1/2 inch lock washer
The bolts must extend at least 1.125 inches above the concrete pad and not more than 1.5
inches about the concrete pad.