User Manual

Removing access panels
IP-RN 8000 Installation & Commissioning Guide 93
6. Remove 15 of the 16 screws holding the surge protection access panel in place. Leave the top middle
screw in place.
7. Hold the surge protection access panel firmly in place and remove the final screw using the tamper
resistant screw driver.
8. Set aside all 16 screws and washers from the surge protection access panel.
These screws will be used to re-install the access panel after all antennas are connected.
This procedure is complete. Go to Installing the Rox System cabinet seal
on page 94.
WARNING
The surge protection access panel is heavy. Take all necessary
precautions to avoid injury and to avoid damaging the access
panel. Do not allow it to be bent. Do not allow the seal around the
inside edge to be damaged.
Surge protection access panel
Cabinet back view
Take care. The access panel is
heavy and requires support