User Manual

Installing the Rox System cabinet seal
IP-RN 8000 Installation & Commissioning Guide 95
6. Gently push the Rox System cabinet seal against the cabinet and position it for final attachment.
7. Screw in the one of the top middle screws by hand.
Be sure to thread the rubber sealing washer on the screw shank before inserting it in the Rox System
screw hole. Check to ensure each screw shank has a spacing washer as well.
8. Start all screws with rubbers washers in by hand. Install them all loosely before tightening any one of
them.
9. Use a torque wrench with a 5/32 inch tamper-resistant hex drive bit set to 18 inch-pounds to tighten all
screws evenly.
This procedure is complete. Go to Connecting GPS and RF antennas
on page 96.
WARNING
Screws should be started by hand. It is possible to damage the
thread in the cabinet if you use a hand tool or a power tool.
Damaged threads must be repaired or the cabinet will be
improperly sealed and the IP-RN 8000 can be damaged. Use a
thread tapping set to fixed damaged threads.
WARNING
If access panels screws are not tightened with the correct torque,
electronic interface may occur causing equipment malfunction.
Rox System cabinet seal
Cabinet back view
positioned for installation
RF and GPS antenna cables
threaded into cabinet