User Manual

Connecting GPS and RF antennas
IP-RN 8000 Installation & Commissioning Guide 99
3. Use the torque wrench set to 10 inch pounds with the 13/16 inch open ended wrench bit to tighten every
antenna cable connection on the surge suppression bar.
4. After all internal antenna cables are connected to the correct surge suppressors, the cabinet appears as
shown in the following figure.
WARNING
Tightening the connectors to more than 15 inch pounds can
damage the equipment.
Rear view - Attaching antenna cables internally
Attach antenna
cables to top of
surge suppression
bar
Ensure the correct
cable is attached to
the right connector
Surge suppression bar
Ensure all cables are
attached