User Manual

Chapter 1 ● Introducing the IP-Radio Node 8000
10 Release 2.0, 910056 Rev01d
Table 6 Access panels
Access panel Description
Standard antenna cable access panel There are four access panels into which the Rox System Cabinet Seal can be
installed. (The Rox System Cabinet Seal is the environmentally sealed unit
through which RF and GPS antenna cables enter the cabinet.) This
installation guide explains how to install the Rox System Cabinet seal into
the standard antenna cable access panel at the top of the back of the cabinet.
Optional antenna cable access
panels
The Rox System Cabinet Seal can optionally be installed into any of three
other antenna access panels. However, these installation options required
non-standard configurations of internal components, and in these cases the
cabinet must be special ordered.
Right side cable access panel There are two access panels through which the power cable, the the backhaul
cable(s), and the alarm cables (if any) can enter the cabinet, one on the right
side, one on the left side. The right side is the standard configuration.This
installation guide explains how to install all systems using the right side
access panel. You can optionally route the backhauls and the power cables
through the left side access panel without special ordering the cabinet as the
internal configurations are identical. This access panel also provides access
to cabinet mounting bolts.
Left side cable access panel The left side has an optional access panel through which the power,
backhaul, and alarms cables can optionally enter the cabinet. This access
panel also provides access to cabinet mounting bolts.
Power terminal access panel Provides access to the power cable terminals and the routing harness for the
backhaul cables.
User equipment access panel Behind this access panel is a chassis placeholder for optional installation of
customer equipment. There is 2U space.
Surge Protection Bar access panel Provides access to the surge Protection bar. All antennas (RF and GPS) must
be connected to the surge protection bar during installation.
Punch block access panel Provides access to the Backhaul Punch Block and the Alarm Punch Block
(reserved for future use). Backhaul connections must be wired to the
Backhaul Punch Block during installation.