User Manual

Unbolting the cabinet from its palette
IP-RN 8000 Installation & Commissioning Guide 57
Unbolting the cabinet from its palette
This procedure explains how to unbolt the cabinet from its shipping palette. At this point, the left side access
panel is removed and the right side access panel is backed away from the cabinet. You now have access to
the four bolts that attach the cabinet to the palette.
Be sure you have read and understood Understanding the cabinet installation process
on page 50 before
continuing.
Requirements
• 5/8 inch open ended wrench
Procedure
1. Using a 5/8 inch open-end wrench, remove the four nuts, lock washers and washers that secure the
cabinet to the pallet.
Access the nuts through the side access panels you have just removed.
2. Set the four nuts, washers, and lock washers aside.
These may be used to bolt the cabinet to the concrete pad. You may also use other nuts and washers that
are appropriate for the type of anchor bolts you have embedded in the concrete pad.
Nut and washers removed
panel removed
Right side access panel
backed away
Bolt pressed down
Left side access