User Manual

Chapter 5 ● Connecting the backhaul
76 Release 2.0, 910056 Rev01d
Removing the punch block access panel
This procedure explains how to remove the punch block access panel.
Be sure you have read and understood Understanding the backhaul installation process
on page 74 before
continuing.
Requirements
• Number 2 Phillips head screwdriver
Procedure
1. Ensure that power is not being delivered to the IP-RN 8000.
a. Ensure the Main Power switch on the Power Distribution Unit is flipped to the right.
See Understanding the Power Distribution Unit
on page 27.
b. Ensure the external circuit breaker that controls power flow to the IP-RN 8000 is opened,
eliminating power on the IP-RN 8000 circuit.
2. Locate the punch block access panel.
See Understanding access panels
on page 9.
3. Using a number 2 Phillips head screw driver, remove the three screws that hold the access panel in
place.
4. Set the access panel and the three screws aside for later re-installation
5. Ensure the power terminal access panel has been removed.
If the power terminal access panel is not currently removed, follow the procedure explained in
Removing the power terminal access panel
on page 204.
This procedure is complete. Go to Routing backhaul to the backhaul punch block
on page 77.
WRIST
STRAP
Wear an ESD strap and connect the strap to the ESD jack in the
Antenna Interface Unit when performing any installation
procedure. See Understanding the Antenna Interface Unit module
on page 17.