User Manual

Chapter 5 ● Connecting the backhaul
78 Release 2.0, 910056 Rev01d
3. Thread the backhaul from the cinch block up the left side of the cabinet between the cabinet and the
chassis frame.
4. Pull the end of the backhaul through the opening at the left side of the backhaul punch block
.
5. Tie and dress the backhaul to secure it along its length inside the cabinet and adjust the position of the
cable with regard to the cinch blocks.
6. When the cable is in its final position, tighten the two screws on the cinch block to hold it securely in
place.
This procedure is complete. Go to Wiring backhaul to the backhaul punch block
on page 79.
NOTE
Be sure to tie the backhaul cables securely to the frame to the left
of the punch block to provide stain relief for the wiring into the
punch block.
Backhaul
punch block
Backhaul cable
Punch block
access panel
Tie and dress
backhaul and thread
through cabinet side
Alarm punch block
(right half)
Pull cable end
through opening