User Manual

6
When is Your AIRAVE Ready for Use?
After installing and turning on your AIRAVE for the first time, AIRAVE goes through an
automated setup sequence. See the table below.
During this time, the device’s green LEDs will be solid for a few seconds, and then all LEDs,
except the Broadband LED, will turn off until the software loads. This process may take up to 2
hours.
When the Broadband, GPS, Network, and Mobile LEDs are solid green, your AIRAVE is ready
for use.
Note: For a summary of LED status indicators, see LED Quick Reference. For complete
descriptions of LED states, see Using LEDs.
Tip: You will hear three short beeps when placing or answering calls on your wireless phone
if you are within range of the AIRAVE.
The following table shows the LED startup sequence.
Broadband GPS Network Mobile AIRAVE State
Solid Green Solid Green Solid Green Solid Green Initial hardware test (5-10 seconds)
Solid Green Off Off Off Software loading (25 seconds or less)
Solid Green Blinking Red Blinking Red Blinking Red Software loaded and Services Started
Solid Green Blinking Red Blinking Red Blinking Red WAN port connected over local network
Solid Green Blinking Red Blinking Red Blinking Red WAN port connected
IPsec tunnel up
Solid Green Solid Green Solid Green Blinking Red WAN port connected
GPS time fix available
IPsec tunnel up
Solid Green Solid Green Solid Green Solid Green WAN port connected
GPS time fix available
IPsec tunnel up
OneX service up