User's Manual
Table Of Contents
- Table of Contents
- Introduction
- Getting Started
- Setting up Optional Components
- Adding Your ISP User Name and Password
- Using Your AIRAVE™
- Troubleshooting
- Troubleshooting Installation Problems
- Troubleshooting Slow Connection When Laptop is Connected to the AIRAVE™
- Troubleshooting Voice Quality Issues
- Resetting the AIRAVE
- /
- LED Quick Reference
- Using LEDs
- FAQs
- Why does the AIRAVE™ need a GPS antenna?
- Why does the AIRAVE™ need an external GPS antenna?
- What happens to the AIRAVE™ if there is a power outage or if you lose Internet access?
- Can you move the AIRAVE™ to another location?
- How do I know if my phone is connecting through the AIRAVE™?
- I have a DSL modem and cannot connect to the Internet
- Getting Help
- Safety Information
- Index
20
Resetting the AIRAVE
If your AIRAVE was operating properly for an extended period and the Mobile LED suddenly
starts blinking red, the AIRAVE may have a problem requiring a reset. To reset the AIRAVE,
push the Reset button for at least 10 seconds (as shown in the drawing below).
After resetting, your AIRAVE goes through an automated setup sequence. During this time, the
device’s green LEDs will be solid for a few seconds, and then all LEDs will turn off until the
software loads. The reset process may take 30-45 minutes.
After resetting the AIRAVE, if the failure persists, contact Customer Care. See Getting Help on
page 26.