User Manual
Table Of Contents
- Contents
- List of figures
- List of tables
- About this document
- ipBTS system overview
- Planning
- ipBTS C30 installation
- RN commissioning
- Requirements
- CLI connection
- Establishing a console connection
- Connecting the laptop to the ipBTS C30
- Downloading and activating new software
- Verifying SNTP time
- Commissioning the ipBTS C30
- Performing Loopback tests
- The loopback test process
- Backhaul loopback testing
- Ethernet loopbacks
- Looping back Ethernet backhaul links
- Looping back at the Ethernet port
- Entering diagnostic mode and configuring test parameters
- Performing external loopback tests on backhaul links
- Troubleshooting failed backhaul links
- Removing physical loopbacks
- Configuring IP on the Ethernet port and laptop
- Establishing the CLI/SSH/Ethernet connection
- Updating node software
- RN hardware components
- RN Specifications
- Hot-swapping ipBTS hardware
- Index
Chapter 1 l ipBTS system overview
ipBTS RN overview
Airvana ipBTS C30 Installation and Commissioning, Release 4.0 1-3
Figure 1-2. ipBTS C30 module functions
Rear view
Figure 1-3 shows the hardware components visible when you view the ipBTS from the rear. .
Figure 1-3. Rear view of a three sector ipBTS
1xEVDO
Modem
System
Controller
Backhaul
Interface
GPS Receiver
and Timing
Radio
Transceiver
GPS Antenna
100BaseT
Backhaul
Console
Port
TX
RX-0
RX-1
Sector
1
-48 VDC
ADCC Module Radio Module
Radio
Transceiver
TX
RX-0
RX-1
Sector
2
Radio
Transceiver
TX
RX-0
RX-1
Sector
3