User Manual

Chapter 3 l ipBTS C30 installation
Connecting the ground
3-6 910136 Rev01.00 Standard July 2007
Procedure
1. Use a box cutter to carefully open the radio module box.
2. Remove the radio module from its protective electrostatic bag and verify that the pins
located on the rear of the module are straight and have not been damaged in shipping.
3. Insert the radio module in the bottom slot of the RN chassis and push in until the
connector engages the backplane and the locking latches (see Figure 3-5) on the left and
right close securely.
4. Use a phillips head screwdriver to engage and tighten the captive screws on the left and
right to hold the radio module in place.
Figure 3-5. Module latch detail
Installing the ADCC module
Airvana packs the ADCC module in a cardboard container measuring approximately 16 in.
(40.6 cm) square, and 3 in. (7.6 cm) deep and weighs approximately 5.6 lbs. (2.5 kg)
Install one ADCC module in the top chassis slot.
Procedure
1. Use a box cutter to carefully open the ADCC module box.
2. Remove the ADCC module from its protective electrostatic bag and verify that the pins
located on the rear of the module are straight and have not been damaged in shipping.
3. Insert the ADCC module in the top slot of the RN chassis and push in until the connector
engages the backplane and the locking latches on the left and right close securely.
4. Use a phillips head screwdriver to engage and tighten the captive screws on the left and
right to hold the ADCC module in place.
Locking latches
Module top view