User Manual
Table Of Contents
- Contents
- List of figures
- List of tables
- About this document
- ipBTS system overview
- Planning
- ipBTS C30 installation
- RN commissioning
- Requirements
- CLI connection
- Establishing a console connection
- Connecting the laptop to the ipBTS C30
- Downloading and activating new software
- Verifying SNTP time
- Commissioning the ipBTS C30
- Performing Loopback tests
- The loopback test process
- Backhaul loopback testing
- Ethernet loopbacks
- Looping back Ethernet backhaul links
- Looping back at the Ethernet port
- Entering diagnostic mode and configuring test parameters
- Performing external loopback tests on backhaul links
- Troubleshooting failed backhaul links
- Removing physical loopbacks
- Configuring IP on the Ethernet port and laptop
- Establishing the CLI/SSH/Ethernet connection
- Updating node software
- RN hardware components
- RN Specifications
- Hot-swapping ipBTS hardware
- Index
Chapter 4 l RN commissioning
Downloading and activating new software
Airvana ipBTS C30 Installation and Commissioning, Release 4.0 4-9
Figure 4-2. HyperTerminal window screen
2. Click the Call icon on the toolbar.
3. Click the
Call using pulldown menu and select TCP/IP (Winsock) as the connection
method.
4. Log in with the Username and
Password.
The ipBts-XXX> prompt displays.
5. At the ipBts-XXX> prompt, enter the following commands to transfer the new image
file to the ipBTS C30:
ipBts-XXX>shell
ipBts-XXX(shell)(disk0:/)>cd images
6. SFTP the new image file.
7. From the ipBts-XXX(shell)(disk0:images)> prompt, enter the following
commands:
ipBts-XXX(shell)(disk0:images)>cd ..
ipBts-XXX(shell)(disk0:)>exit
ipBts-XXX>
8. Close the HyperTerminal window.
A message displays confirming you want to disconnect.
9. Click Ye s to disconnect or No to not disconnect.
Expanding and activating the new image file
Follow this procedure to expand and activate <software_image>.tar. This procedure assumes
you have an active CLI/serial connection to the ADCC module.
1. Enter the following commands to enter Global Commissioning Mode in the CLI: