Users Manual Part 2

Appendix E Cable installation and power separation guidelines
ONECELL
®
Hardware Installation, Release 5.5 E-5
D
R
A
F
T
2 Position the filled tube to overlap the end of the inner jacket and seal the gel.
Clean off all excess sealant.
NOTE: Tape can be used to stabilize the tube for immediate termination before
the sealant sets.
Cable termination
Shielded cables must be properly terminated, either grounded or isolated. For exposed
installations requiring protection, the end of the shield can be bonded in various ways.
The following procedure is an example of one method.
1 Make a slit along the length of the jacket. Be careful not to tear the underlying
shielding.