Users Manual Part 1

Chapter 6 RP2000 Installation
OneCell
®
Hardware Installation, Release 4.5 6-17
D
R
A
F
T
Flown mount
The Radio Point can be flown mounted on the end of a rod. This configuration is used
for buildings where there are no drop ceilings.
Mounting the Radio Point (RP) in the flown configuration requires the hardware listed
in Indoor Radio Point (RP2000) installation overview on page 6-2
Figure 6-3. CommScope supplied kit contents
Mounting the Radio Point (RP) in the flown configuration requires the following
hardware provided by the system integrator:
• Rod, 3/8-inch threaded
• 2 flat washers
• Nut
• Lock nut, nylon