Installation Guide

Chapter 7 RP2100 Installation
7-3 M0303A2 4.5.03 December 2020
D
R
A
F
T
Mounting the Radio Point (RP) on a wall requires the following hardware provided by
the system integrator:
• Four molly screws capable – 50 lb (23 kg) minimum rating
Before installing the RP on the pole, terminate the RP end of the Ethernet cable with
the RJ45, IP67 connector provided in the box.
NOTE
Once the Radio Point is installed and the powered on, it may take up to 20 minutes
for the frequency to stabilize and lock.