Specifications

Appendix B Installation troubleshooting
OneCell
®
Hardware Installation, Release 4.5 B-7
D
R
A
F
T
RP2000 series LED patterns
The RP2000 and RP2100 Radio Points have one LED. The LED for the RP2000
(Indoor) is on the front cover. The LED for the RP2100 (Rugged) is on the bottom of
the Radio Point where the Ethernet cable port is located. The following table shows:
• Display pattern for each LED
• What the pattern indicates
• Action to take, if any, to resolve the issue
LED Display Pattern Indicates Action to Take
STATUS Green, solid Power On
RFTx state is ON
None
Amber, solid Self-test failure Replace RP
Green, blinking Firmware upgrade
Connected to Baseband Controller
None
Amber, blinking PLL state – unlock
RFTx state – OFF or suspended
L2 path verification failed
Admin state – STANDBY
• Check 1588 VLAN configuration
• Verify RP is in STANDBY because
more than 32 Radio Points are
connected to the same Baseband
Controller
Red, blinking No connection to Baseband Controller
(http)
• Connect the Ethernet cable between the
Baseband Controller and Radio Point
• Replace RP
Red, solid Error in system – software or hardware
issues
Interface issues detected
AdminState – UNLOCKED
• Connect the Ethernet cable between the
Baseband Controller and Radio Point
• Upgrade Radio Point
• Replace Radio Point