User Guide
Table Of Contents
- Contents
- List of figures
- List of tables
- New in this release
- About this document
- Introduction
- Getting Started
- Configuring the S1000C Router
- Using the S1000C
- Troubleshooting
- Troubleshooting installation problems
- Resetting the S1000C
- LED quick reference
- Router connection problems
- Using LEDs
- FAQs
- Why does the S1000C need a GPS antenna?
- Why does the S1000C need an external GPS antenna?
- What should I do if the GPS fails to acquire a lock?
- What happens to the S1000C if there is a power outage or if you lose Internet access?
- Can you move the S1000C to another location?
- I have a DSL modem and cannot connect to the Internet
- My calls work fine outside but drop indoors
- My Internet connection is slow when my laptop is connected to the S1000C
- Getting help
- Safety information
Chapter 2 Getting Started
2-6 913114 1.5.01 August 2016
DR
AFT
NOTE
Wait a couple of minutes for the broadband device to fully initialize before
continuing.
7 Plug the power supply connector into the black power port on your S1000C.
Figure 2-5. Power supply connection
Power
Supply
S1000C
8 Stand the unit upright and carefully move all cables so they come out of one long
end of the unit.
NOTE: There is room for cables to come out from the beneath the unit once it is
placed upright.
9 Plu
g the other end of the power cable into an available electrical outlet. (We
recommend a surge protected outlet.)