User Guide
Table Of Contents
- Contents
- List of figures
- List of tables
- New in this release
- About this document
- Introduction
- Getting Started
- Configuring the S1000C Router
- Using the S1000C
- Troubleshooting
- Troubleshooting installation problems
- Resetting the S1000C
- LED quick reference
- Router connection problems
- Using LEDs
- FAQs
- Why does the S1000C need a GPS antenna?
- Why does the S1000C need an external GPS antenna?
- What should I do if the GPS fails to acquire a lock?
- What happens to the S1000C if there is a power outage or if you lose Internet access?
- Can you move the S1000C to another location?
- I have a DSL modem and cannot connect to the Internet
- My calls work fine outside but drop indoors
- My Internet connection is slow when my laptop is connected to the S1000C
- Getting help
- Safety information
S1000C User Guide, Release 1.5 3-1
D
R
A
F
T
Chapter 3
Configuring the S1000C Router
This chapter describes how to configure the internal router:
• Overview on page 3-1
• Logging in to the S1000C router on page 3-3
• Configuring WiFi service on page 3-5
• Adding your ISP User Name and Password on page 3-14
Overview
Your S1000C contains a built-in router. Usually, you can plug your S1000C into your
broadband connection device, such as a cable modem, DSL modem or FIOS (a high-
speed, fiber optic broadband Internet service), without performing any additional
steps. However, you may need to configure the built-in router to work with your ISP
modem or connection device.
The following table lists typical ISP setups and actions to take so that the built-in
router works with your existing ISP setup.
For a complete description of the S1000C router configuration, refer to Airvana S1000
Web GUI User Guide (913110).
Broadband
connection device
LED display
pattern
Symptom Action to take
Cable modem WAN, LTE and WiFi solid
green
Not applicable (working
properly)
Not applicable
DSL modem WAN LED blinking red Cannot access Internet Go to Adding your ISP
User Name and Password