User Guide
Table Of Contents
- Contents
- List of figures
- List of tables
- New in this release
- About this document
- Introduction
- Getting Started
- Configuring the S1000C Router
- Using the S1000C
- Troubleshooting
- Troubleshooting installation problems
- Resetting the S1000C
- LED quick reference
- Router connection problems
- Using LEDs
- FAQs
- Why does the S1000C need a GPS antenna?
- Why does the S1000C need an external GPS antenna?
- What should I do if the GPS fails to acquire a lock?
- What happens to the S1000C if there is a power outage or if you lose Internet access?
- Can you move the S1000C to another location?
- I have a DSL modem and cannot connect to the Internet
- My calls work fine outside but drop indoors
- My Internet connection is slow when my laptop is connected to the S1000C
- Getting help
- Safety information
Chapter 3 Configuring the S1000C Router
S1000C User Guide, Release 1.5 3-5
DR
AFT
Configuring WiFi service
Follow this section to setup the S1000C’s WiFi service. You will create and configure
SSIDs in the router.
1 Lo
g into the S1000C router by following the procedure in Logging in to the
S1000C router.
2 Fro
m the Home page click WiFi.
Basic Settings
On the Basic Settings tab, you to enable and co
nfigure the two radios available in the
S1000C. Radio 1 has a frequency of 5.0 GHz and Radio 2 has a frequency of 2.4 GHz
Figure 3-1. Basic Settings page
Table 3-1. Basic Settings parameters
Parameter Description
Enable Radio Enable or disable Radio 1 and Radio 2
Operating Mode The following options are
supported on Radio 1:
• IEEE 802.11ac
• IEEE 802.11n
• IEEE 802.11a
The following options are
supported on Radio 2:
• IEEE 802.11n
• IEEE 802.11g
• IEEE 802.11b