Users Manual Part 1

M0201AYA_uc CommScope Era

™

CAP M 4/70/80

Safely Working with Era Hardware

General Installation Safety Requirements

Wet conditions increase the potential for receiving an electrical shock when installing or using electrically

powered equipment. To prevent electrical shock, never install or use electrical equipment in a wet

location or during a lightning storm.

This system is a RF Transmitter and continuously emits RF energy. Maintain a minimum 8-inch (20 cm)

clearance from the antenna while the system is operating. Whenever possible, shut down the RAN before

servicing the antenna.

Do not remove caps from any of the connectors until instructed to do so.

The CAP M is to be used only with CommScope (NEC Class 2) or Limited Power Source Era Subrack, or

equivalent.

Read and observe all the warning labels attached to the unit. Make sure that all warning labels are kept

in a legible condition. Replace any missing or damaged labels.

Read and obey all the warning labels attached to the unit. Make sure that all warning labels are kept in a

legible condition. Replace any missing or damaged labels.

Make sure the unit's settings are correct for the intended use (refer to the manufacturer product

information) and regulatory requirements are met. Do not carry out any modifications or fit any spare

parts, which are not sold or recommended by the manufacturer.

Due to power dissipation, the CAP M may reach a very high temperature. Do not operate this equipment

on or close to flammable materials. Use caution when servicing the CAP

Only authorized and trained personnel are allowed to open the unit and get access to the inside.

Only suitably qualified personnel are allowed to work on this unit and only after becoming familiar with

all safety notices, installation, operation and maintenance procedures contained in this installation

guide.

Although the unit is internally protected against overvoltage, it is strongly recommended to ground

(earth) the antenna cables close to the antenna connectors of the unit for protection against atmospheric

discharge. In areas with strong lightning, it is strongly recommended to install additional lightning

protection.