Users Manual Part 1

M0201AYA_uc CommScope Era

™

CAP M 4/70/80

Installing CAP Ms

8 Use both handles on the CAP M-1 chassis to lift it above the Mounting Bracket, and with the front of the

chassis facing the mounting surface, lower it into place.

• The M6 pin

s that you loosened in Step 7 on page 36 must align with the Mounting Bracket slots, as

shown below.

• The

washer for each M6 pin should be next to the CAP M-1 chassis (inside the bracket).

M6 Pin with its

washer on the inside

of the bracket,

against the

CAP-M1 chasssis

CAP M-1

(front of the CAP M-1 chassis

faces the mounng surface)



9 On the right side of the CAP M-1, torque the M6 pin to 11 N-m.

10 Rep

eat Step 9 on the left side of the CAP M.