Users Manual Part 1
CommScope Era
™
CAP M 4/70/80 M0201AYA_uc
Page 40 © October 2019 CommScope, Inc.
Installing CAP Ms
14 Use both handles on the CAP M-2 chassis to lift it above the Mounting Bracket with the back of its chassis
facing the back of CAP M-1, and then lower it into place.
• The M6 pin
s that you loosened in Step 13 on page 39 must align with the Mounting Bracket slots, as
shown below.
• The
washer for each M6 pin should be next to the CAP M-2 chassis (inside the bracket).
CAP M-2
(back of the CAP M-2 chassis
faces the back of CAP M-1)
M6 Pin with its
washer on the inside
of the bracket,
against the
CAP-M2 chasssis
15 On the right side of the CAP M-2, torque the M6 pin to 11 N-m.
16 Rep
eat Step 15 on the left side of the CAP M.