Installation Guide
Table Of Contents
- Table of Contents
- Document Overview
- Era System Overview
- CAP M Overview
- Safely Working with Era Hardware
- Installing CAP Ms
- CAP M Installation and Cascade Rules
- Cat6A Cable Requirements for Ethernet Devices
- Prepare for Installation
- Wire an Optional Hybrid Fiber Splice Box
- Mount the CAP M
- Grounding the CAP M
- Connect the CAP M Cables
- Power the CAP M
- Contacting CommScope
- CMS Global Technical Support
- Waste Electrical and Electronic Equipment Recycling
- Hardware to Software Mapping Information
- CMS Technical Training
- Accessing Era User Documentation
M0201AJE_uc CommScope Era
™
Medium Power Carrier Access Point Installation Guide
© February 2020 CommScope, Inc. Page 11
Safely Working with Era Hardware
Property Damage Warnings
Keep operating instructions within easy reach and make them available to all users.
Only license holders for the respective frequency range are allowed to operate this unit.
Read and obey all the warning labels attached to the unit. Make sure that all warning labels are kept in a
legible condition. Replace any missing or damaged labels.
Make sure the unit's settings are correct for the intended use (refer to the manufacturer product
information) and regulatory requirements are met. Do not carry out any modifications or fit any spare
parts, which are not sold or recommended by the manufacturer.
Due to power dissipation, the CAP M may reach a very high temperature. Do not operate this equipment
on or close to flammable materials. Use caution when servicing the CAP
M.
Only authorized and trained personnel are allowed to open the unit and get access to the inside.
Only suitably qualified personnel are allowed to work on this unit and only after becoming familiar with
all safety notices, installation, operation and maintenance procedures contained in this installation
guide.
Although the unit is internally protected against overvoltage, it is strongly recommended to ground
(earth) the antenna cables close to the antenna connectors of the unit for protection against atmospheric
discharge. In areas with strong lightning, it is strongly recommended to install additional lightning
protection.