Installation Guide

CommScope Era
™
Medium Power Carrier Access Point Installation Guide M0201AJE_uc
Page 16 © February 2020 CommScope, Inc.
Safely Working with Era Hardware
• Reorient or relocate the receiving antenna.
• Increase
the separation between the equipment and receiver.
• C
onnect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
• Consul
t the dealer or an experienced radio/TV technician for help.
9 Noti
ce: For a Class A digital device or peripheral.
This equipment has been tested and found to comply with the limits for a Class A
digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial environment. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference in which case the user will be
required to correct the interference at his own expense.
10 Note:This unit
complies with European standard EN60950-1 / EN62368-1.
Equipment Symbols Used / Compliance
Please observe the meanings of the following symbols used in our equipment and the compliance warnings
listed in Table 5.
Table 5. Compliance Labels
Symbol Compliance Meaning
— FCC
For industrial (Part 20) signal booster:
WARNING: This is NOT a CONSUMER device. It is des
igned for installation by FCC LICENSEES and
QUALIFIED INSTALLERS. You MUST have an FCC LICENSE or express consent of an FCC Licensee to
operate this device. Unauthorized use may result in significant forfeiture penalties, including
penalties in excess of $100,000 for each continuing violation.
For (Part 90) signal booster:
WARNING: This is NOT a CONSUMER device. It is des
igned for installation by FCC LICENSEES and
QUALIFIED INSTALLERS. You MUST have an FCC LICENSE or express consent of an FCC Licensee to
operate this device. You MUST register Class B signal boosters (as defined in 47 CFR 90.219) online
at www.fcc.gov/signal-boosters/registration. Unauthorized use may result in significant forfeiture
penalties, including penalties in excess of $100,000 for each continuing violation.
— ISED
WARNING: This is NOT a CONSUMER
device. It is designed for installation by an installer approved
by an ISED licensee. You MUST have an ISED LICENCE or the express consent of an ISED licensee
to operate this device.
AVERTISSEMENT: Ce produit N'EST PAS un appareil de CONSOMMATIO
N. Il est conçu pour être
installé par un installateur approuvé par un titulaire de licence d'ISDE. Pour utiliser cet appareil,
vous DEVEZ détenir une LICENCE d'ISDE ou avoir obtenu le consentement exprès d'un titulaire de
licence autorisé par ISDE.
CE
To be sold exclusively to mobile operators or authorized installers - no harmonized frequency
b
ands, operation requires license. Intended use: EU and EFTA countries.
Indicates conformity with the RED
directive 2014/53/EU and/or RoHS directive 2011/65/EU.
CE
Indicates conformity with the RED directive 2014/53/
EU and RoHS directive 2011/65/EU certified
by the notified body no. 0700.