Installation Guide

Table Of Contents

M0201AJE_uc CommScope Era

™

Medium Power Carrier Access Point Installation Guide

Installing CAP Ms

Unpack and Inspect the CAP M and Optional Accessories

1 Inspect the exterior of the shipping container(s) for evidence of rough handling that may have damaged

the components in the container.

2 Unpack each c

ontainer while carefully checking the contents for damage and verify with the packing slip.

3 If

damage is found or parts are missing, file a claim with the commercial carrier and notify CommScope

Technical Support (see "CMS Global Technical Support” on page 61). Save the damaged cartons for

inspection by the carrier.

4 Save

all shipping containers for use if the equipment requires shipment at a future date.

Wire an Optional Hybrid Fiber Splice Box

The steps in this section pertain only to those installations that require the use of the optional Hybrid

Fiber Splice Box to provide fiber and power to the CAP M. If the optional Hybrid Fiber Splice Box is not

required for this installation,

skip to "Mount the CAP M” on page 27.

1 Obtain

the Hybrid Fiber Splice Box Kit (CommScope PN 7693816-xx).

2 Foll

ow the steps in "Unpack and Inspect the CAP M and Optional Accessories” on page 23.

3 Open the Hybrid Fiber Splice Box and remove the installation kit that is

inside.

4 Using the parts from the Hybrid Fiber Splice Box, insert the Splice Holder

and fasten it using a PTK 30x6

screw and one M4 washer.