Installation Guide
Table Of Contents
- Table of Contents
- Document Overview
- Era System Overview
- CAP M Overview
- Safely Working with Era Hardware
- Installing CAP Ms
- CAP M Installation and Cascade Rules
- Cat6A Cable Requirements for Ethernet Devices
- Prepare for Installation
- Wire an Optional Hybrid Fiber Splice Box
- Mount the CAP M
- Grounding the CAP M
- Connect the CAP M Cables
- Power the CAP M
- Contacting CommScope
- CMS Global Technical Support
- Waste Electrical and Electronic Equipment Recycling
- Hardware to Software Mapping Information
- CMS Technical Training
- Accessing Era User Documentation
M0201AJE_uc CommScope Era
™
Medium Power Carrier Access Point Installation Guide
© February 2020 CommScope, Inc. Page 37
Installing CAP Ms
7 From both sides of CAP M-1:
a L
oosen the M6 pins, leaving its washer in place.
b Remove
the two M6 screws and their M6 plain and M6 split-lock washers; reserve the screws and
washers as you will later reinstall them.
M6 plain washer
M6 split-lock washer
M6x12 screw
Loosen the M6 pin
Remove the M6x12 screw and its washers