Installation Guide
Table Of Contents
- Table of Contents
- Document Overview
- Era System Overview
- CAP M Overview
- Safely Working with Era Hardware
- Installing CAP Ms
- CAP M Installation and Cascade Rules
- Cat6A Cable Requirements for Ethernet Devices
- Prepare for Installation
- Wire an Optional Hybrid Fiber Splice Box
- Mount the CAP M
- Grounding the CAP M
- Connect the CAP M Cables
- Power the CAP M
- Contacting CommScope
- CMS Global Technical Support
- Waste Electrical and Electronic Equipment Recycling
- Hardware to Software Mapping Information
- CMS Technical Training
- Accessing Era User Documentation
CommScope Era
™
Medium Power Carrier Access Point Installation Guide M0201AJE_uc
Page 38 © February 2020 CommScope, Inc.
Installing CAP Ms
8 Use both handles on the CAP M-1 chassis to lift it above the Mounting Bracket, and with the front of the
chassis facing the mounting surface, lower it into place.
• The M6 pin
s that you loosened in Step 7 on page 37 must align with the Mounting Bracket slots, as
shown below.
• The
washer for each M6 pin should be next to the CAP M-1 chassis (inside the bracket).
M6 Pin with its
washer on the inside
of the bracket,
against the
CAP-M1 chasssis
CAP M-1
(front of the CAP M-1 chassis
faces the mounng surface)
9 On the right side of the CAP M-1, torque the M6 pin to 11 N-m.
10 Rep
eat Step 9 on the left side of the CAP M.