Installation Guide
Table Of Contents
- Table of Contents
- Document Overview
- Era System Overview
- CAP M Overview
- Safely Working with Era Hardware
- Installing CAP Ms
- CAP M Installation and Cascade Rules
- Cat6A Cable Requirements for Ethernet Devices
- Prepare for Installation
- Wire an Optional Hybrid Fiber Splice Box
- Mount the CAP M
- Grounding the CAP M
- Connect the CAP M Cables
- Power the CAP M
- Contacting CommScope
- CMS Global Technical Support
- Waste Electrical and Electronic Equipment Recycling
- Hardware to Software Mapping Information
- CMS Technical Training
- Accessing Era User Documentation
M0201AJE_uc CommScope Era
™
Medium Power Carrier Access Point Installation Guide
© February 2020 CommScope, Inc. Page 39
Installing CAP Ms
11 On lower right of the CAP M-1, reinstall the M6x12 screw and its washers that you removed in Step 7 on
page 37.
a Slide first the
M6 split-lock washer and then the M6 plain washer over the M6x12 screw.
b Insert the
M6x12 screw through the screw hole shown below, and screw it back into the CAP M-1
chassis; torque to 11 N-m.
M6x12 screw and
washer set in hole
closest to the
mounng surface
12 Repeat Step 11 on the left side of the CAP M-1.