Installation Guide
Table Of Contents
- Table of Contents
- Document Overview
- Era System Overview
- CAP M Overview
- Safely Working with Era Hardware
- Installing CAP Ms
- CAP M Installation and Cascade Rules
- Cat6A Cable Requirements for Ethernet Devices
- Prepare for Installation
- Wire an Optional Hybrid Fiber Splice Box
- Mount the CAP M
- Grounding the CAP M
- Connect the CAP M Cables
- Power the CAP M
- Contacting CommScope
- CMS Global Technical Support
- Waste Electrical and Electronic Equipment Recycling
- Hardware to Software Mapping Information
- CMS Technical Training
- Accessing Era User Documentation
CommScope Era
™
Medium Power Carrier Access Point Installation Guide M0201AJE_uc
Page 40 © February 2020 CommScope, Inc.
Installing CAP Ms
13 From both sides of CAP M-2:
a L
oosen the M6 pins, leaving its washer in place.
b Remove
the two M6 screws and their washers; reserve the screws and washers as you will later
reinstall them.
Loosen the M6 pin
Remove the M6 screw
and its washer