Installation Guide

M0201AJE_uc CommScope Era
™
Medium Power Carrier Access Point Installation Guide
© February 2020 CommScope, Inc. Page 45
Installing CAP Ms
9 Attach four of the threaded bolts to the side of the top Pole-Mounting Bracket that will face toward the
pole (inside the Pole-Mounting Bracket). Install the M8 nut and washers in the order shown.
a
Bracket
Threaded
bolts
9A
9B
Pole
Mounng
Bracket
12C
Threaded
bolts
12A
12B
4" to 18"
(10.2 cm to 45.8 cm)
Slide one M8 plain
washer (9A) t
o one
end of each of the four
threaded bolts.
b Slide an M8 Hexagon
Nut (9B) next to
the
M8 plain washer.
c Torque the
M8
Hexagon Nut to 27
N-m.
10 Rep
eat Step 9, but this
time attach four of the
threaded bolts
to the
bottom Pole-Mounting
Bracket.
11 O
ne installer should now
hold the Pole-Mounting
Brackets that you
assembled in Step 7
through Step 10 against
in the pole at the position
at whic
h the CAP M is to
be at
tached to the pole.
The eight threaded bolts
will protrude to the other
side of the pile.
12 T
he second installer
should now attach one of
the Brackets to the top
four threaded bolts that protrude past the pole. Install the M8 nut and washers in the order shown.
a Slide one M8 plain washer
(12A) to one end of each of the four threaded bolts.
b Slide an M8 sp
lit-lock washer (12B) next to the M8 plain washer.
c Use an
M8 nut (12C) to screw the end of the threaded bolts (with the nut and washer) to the welded
nuts on the inner side of the top Pole-Mounting Bracket.
d Torque
the M8 Hexagon Nut to 27 N-m.
13 Rep
eat Step 12, but this time attach the second Bracket to the bottom four threaded bolts.
14 To mount t
he CAP M to the pole-mounting kit, follow the steps in "Mount a CAP M Using a Single Mounting
Bracket” on page 29 or "Mount Two CAP Ms Using a Dual Mounting Bracket” on page 35, as appropriate
for this installation.