Installation Guide
Table Of Contents
- Table of Contents
- Document Overview
- Era System Overview
- CAP M Overview
- Safely Working with Era Hardware
- Installing CAP Ms
- CAP M Installation and Cascade Rules
- Cat6A Cable Requirements for Ethernet Devices
- Prepare for Installation
- Wire an Optional Hybrid Fiber Splice Box
- Mount the CAP M
- Grounding the CAP M
- Connect the CAP M Cables
- Power the CAP M
- Contacting CommScope
- CMS Global Technical Support
- Waste Electrical and Electronic Equipment Recycling
- Hardware to Software Mapping Information
- CMS Technical Training
- Accessing Era User Documentation
CommScope Era
™
Medium Power Carrier Access Point Installation Guide M0201AJE_uc
Page 46 © February 2020 CommScope, Inc.
Installing CAP Ms
Attach a Hybrid Fiber Splice Box to the CAP M
The steps in this section pertain only to those installations that require the use of the optional Hybrid
Fiber Splice Box to provide fiber and power to the CAP M. If the optional Hybrid Fiber Splice Box is not
required for this installation,
skip to "Grounding the CAP M” on page 50.
Follow the procedure that is appropriate for this installation:
• "Attaching a Hybrid Fiber Splice Box for a
Single Mount Installation” on page 46
• "Attaching a Hybrid Fiber Splice Box for a Dual Mount Installation” on page 48.
Attaching a Hybrid Fiber Splice Box for a Single Mount Installation
1 Hang the Splice Box onto the Single Mounting Bracket on the right-hand side of the CAP M, as shown
below.
Single
Mounng
Bracket
Hybrid Fiber
Splice Box