Users Manual Part 2

Appendix E Cable installation and power separation guidelines
OneCell
®
Installation, RP5000 series, Release 4.0 E-5
DR
AFT
2 Position the filled tube to overlap the end of the inner jacket and seal the gel.
Clean off all excess sealant.
NOTE: Tape can be used to stabilize the tube for immediate termination before
the sealant sets.
Cable termination
Shielded cables must be properly terminated, either grounded or isolated. For expose
d
installations requiring protection, the end of the shield can be bonded in various ways.
The following procedure is an example of one method.
1 Make a slit
along the length of the jacket. Be careful not to tear the underlying
shielding.