Users Manual Part 2

Appendix E Cable installation and power separation guidelines

E-12 M0300A2 4.0.11 January 2020

AFT

For an isolated shield termination, the 1572A and 1592A outer jacket foil and drain

wire are removed a short distance back from the termination and electrical tape is used

to isolate the foil end.

Lightning protection

CommScope recommends including lightning protection in your OneCell system to

isolate equipment from surge damage.

Important guidelines

• Verify hole diameter – blocking may need to remain outside the cover

• Maintain pair twists up

to termination points

• Avoid having pairs crossing over each other

Indoor box

To protect the cables in an indoor installation from li

ghtning damage, CommScope

recommends using the

ITW Linx CAT6-A-LAN protector.

NOTE

The gel filled outdoor cable types will still need blocking. See Cable splicing and

Cable termination for instructions on blocking cable.