User's Guide

AWS 120W MCPA User Guide Page 2
Communication Components Inc.
89 Leuning Street
South Hackensack, NJ 07606
Phone: [phone]
Fax: [phone]
www.cciproducts.com
Figure 1 - “Typical Site Installation Config.” Block Diagram for AWS 120W Cell Extender
Setting the RF Output Power to the MCPA-2100-125 Multi-Carrier Power Amplifier:
The RF output power is not adjustable on the AWS MCPA Amplifier. The user must adjust the
RF input power to the AWS MCPA Amplifier such that the RF output power level does not exceed
the levels shown below in order for the RF output spectral emissions to be compliant with the
FCC spurious emissions limit of -13 dBm outside of the assigned frequency block. These levels
must not be exceeded. The total output power at the antenna terminal output of the device
must not exceed the peak output power of 125.9W.
*Note: The Maximum RF Output Power is after any passive losses after the MCPA Module such
as filters and cables.
This equipment complies with Part 24 of the FCC rules. Any changes or modifications not
expressly approved by the manufacturer could void the user’s authority to operate the equipment.
In order to comply with FCC rules for RF exposure, it must be observed that the antenna
connected to this equipment be fixed on an outdoor structure and that it must have a minimum
separation distance of 10 meters between it and any person.
30dB
Coupler
Diplexer
AWS BTS
Tx/RxM RxD
TMA
+6dB
Atten
AA
ANT
T
+51dBm Output
2100
MCPA
+9dBm Input Max
AA
ANT
T
ANT
Tx Rx
TMA
+46dBm,
+16dBm
+9dBm
+51dBm
+50.7dBm
Center Channel
Frequency (MHz)
Maximum RF
Output (Watt)*
2110 - 2155
117.5