Installation guide

EQ - EQ paramters
OUT
_
1:XXXXXX MENU:EQ
EQ# :1 BW:0.33oct
LEVEL:0.00dB Q=4.36
FREQ :1000Hz TYPE:Param
 Refer to the Input Menus for details
XOver - Crossover parameters
 FTRL - Filter Type of low frequency crossover point (high pass). Types can be Buttwrth
(Butterworth), Link-Ri (Linkritz Riley) or Bessel.
 FRQL - Filter cut-off Frequency of low frequency crossover point (high pass). Ranges
from 20 to 20,000Hz in either 1Hz steps or 1/36 octave steps. The frequency steps can
be selected in the System Menu.
 SLPL - Filter Slope of low frequency crossover point (high pass). Ranges from 6 to
48dB/octave (48kHz) or 6 to 24dB/octave (96kHz) in 6dB/octave steps. If the selected
Filter Type is Linkritz Riley, the available slopes are 12 / 24 / 36 / 48 dB/octave (48kHz)
or 12 / 24 (96kHz).
 FTRH - Filter Type of high frequency crossover point (low pass).
 FRQH - Filter cut-off Frequency of high frequency crossover point (low pass).
 SLPH - Filter Slope of high frequency crossover point (low pass).
Filter
configuration
Low crossover
point
High crossover
point
None FTRL Off FTRH Off
Highpass FTRL not Off FTRH Off
FRQL
Lowpass FTRL Off FTRH not Off
FRQH
Bandpass FTRL not Off FTRH not Off
FRQL FRQH
OUT
_
1:XXXXXX MENU:XOver
FTRL:Off FTRH:Off
FRQL:1000Hz FRQL:1000Hz
SLPL:24dB SLPH:24dB
Community DXP4800 Owner’s Manual Page 10