Installation guide

SYSTEM-SETUP MENU:Recall
PROG:01
NAME:XXXXXXXXXXXX
 PROG - Program Number to be recalled..
 NAME - Program Name of the program. This is read only, the user has no access to
them.
Store - Program store
The DXP4800 has a built in non-volatile memory that can store up to 30 different program
setups. A program can be stored using this menu. The old program with the same program
number will be replaced. Once the program is stored in the flash memory, it can be recalled at a
later time, even after power down.
SYSTEM-SETUP MENU:Store
PROG:01
NAME:XXXXXXXXXXXX
 PROG - Program Number for the current data to be stored.
 NAME - Program Name, allows a maximum length of 12 characters.
Config - Device Configuration
SYSTEM-SETUP MENU:Config
MODE:2-Way
 MODE - configures the mode of operation.
Mode: Out 1 Out 2 Out 3 Out 4 Out 5 Out 6 Out 7 Out 8
None Any Any Any Any Any Any Any Any
Stereo 2-Way In1 In1 In2 In2 Any Any Any Any
Stereo 3-Way In1 In1 In1 In2 In2 In2 Any Any
Stereo 4-Way In1 In1 In1 In1 In2 In2 In2 In2
The unit assigns the Input source for the corresponding outputs when the Mode of Configuration
is selected. The crossover point parameters like the filter type, cut-off frequency and slope have
to be configured manually in the Xover Menu in each Output menu.
*Note: The configuration mode configures the input sources when selected. The user can
change the source afterwards if desired. It does not keep the configuration in memory.
Community DXP4800 Owner’s Manual Page 12