Owner`s manual

Community Professional Loudspeakers MVP™ Series II Owner’s Manual
14
Grille Installation
The socket head screws in the four grille clamps should still be in their loosened condition, as they were left
when the grille was removed. Pull upward on the end of each grille clamp to be sure it has returned to its
natural unclamped position. Slide one side of the grille down between the clamps and the side of the cabinet
until the edge of the grille rests on the face of the cabinet.
Note: Occasionally one of the clamps will engage the edge of the grille and prevent it from seating properly on the face. If this
occurs, insert the short arm of the key through the grille about ¾” (19 mm) to one side of the clamp. Hook the short arm of the
key under the end of the clamp and pull it up. This will disengage the clamp from the grille and allow the grille to be pushed down
until it is seated on the face. (see drawing below)