Installation manual

Community S-Series - Operation and Installation Manual - Page 11
PHYSICAL FEATURES OF S-SERIES FULL-RANGE MODELS
FEATURE DESCRIPTION
TOP & BOTTOM RIGGING
POINTS
8 total, 4 top and 4 bottom - bottom points not shown
1
(note: S-SERIES-1296 has 3 top and 3 bottom).
ERGO-GRIP SIDE LIFTING
HANDLES
2 total.
PROTECTIVE GRILLE
Powder-coated steel grille protects drivers
from foreign objects.
GRILLE RETENTION
SCREWS
Eight (or ten) #6 x 5/8” sheet metal screws,
depending on model.
REAR ERGO-GRIP
LIFTING HANDLE
1 total.
REAR PULL-BACK POINTS
Used for angling enclosure downward; not for primary
rigging.
INPUT PANEL
For amplifier connection to the loudspeaker. Also
contains Bi-amp / Single-amp switch, Presence switch,
and DYNA-TECH
TM
Protection Indicator.
POLE SUPPORT
RECEPTACLE
Installed on bottom of enclosure. Accepts standard
loudspeaker support pole (1.375” / 35 mm diameter).
FEET 4 synthetic-rubber feet protect surfaces from marring.
PASSIVE / BI-AMP
SWITCH
Used to select loudspeaker’s operating mode. LEFT
position is for PASSIVE mode (single amplifier) and
RIGHT position is for BI-AMPLIFIED mode (separate
LF and HF amplifiers).
NL4-COMPATIBLE
LOCKING CONNECTORS
Two 4-pole NL4MP type loudspeaker connectors wired
in parallel. Accepts NL4FC connectors. Used for both
PASSIVE and BI-AMPLIFIED modes. Use terminals #1
+/– for PASSIVE mode or for BI-AMPLIFIED LF input.
Use terminals #2 +/– for BI-AMPLIFIED HF input (not
used in PASSIVE mode).
¼” JACKS Wired in parallel with Pins #1+ and #1- of both NL4MP
connectors. Note: may only be used in PASSIVE mode.
DYNA-TECH
TM
PROTECTION INDICATOR
Red LED indicates that DYNA-TECH active protection
circuits have been engaged, reducing the potential of
driver damage.
PRESENCE SWITCH
Selects between MUSIC (Flat) and VOICE/ SPEECH
(+4dB) operating modes (LEFT position is MUSIC
(Flat), RIGHT is VOICE/SPEECH). Re-voices the
loudspeaker’s tonal balance for increased articulation
in the vocal range.
1
100 lbs (45.4 kg) Working Load Limit / 10:1 safety factor