Installation manual

Community S-Series - Operation and Installation Manual - Page 49
Figure 15: STKIT Assembly of S-Series Enclosure with 4 Seat Track
Channels and M10 Hardware
(4) 8 x 1" PHIL
DSCREWS
FLATHEAD LIPS
RIVE DEEP THREAD
(4) FLATHEAD ALLEN DRIVE SCREW
S
(M10 x 40mm OR 3/8-16 x 1.5”)
(4) SEAT TRACK CHANNELS
IMPORTANT SAFETY WARNING: The STKIT is supplied with both 3/8-16 Unified Course
and 10mm Metric fasteners. These fasteners are very similar but they are NOT identical. It
is critically important that you use the M10 fasteners with all S- Series enclosures. DO NOT
USE THE 3/8-16 UNC fasteners under any circumstances. Use of fasteners with the
incorrect thread pitch could result in serious harm, injury or death, because the
threads will not hold securely under load.
2. Vertical Fly Kit: VFKIT
A Vertical Fly Kit, designated the VFKIT, is available to fit the trapezoidal full-range S-
1596, S-3294 and S-3594 loudspeakers.
The kit consists of two flat steel plates, slotted to align with the S-Series rigging fittings on
the tops and bottoms of the enclosures, and four eyebolts. It allows a pair of S-Series
enclosures to be flown in a horizontal splayed-array orientation.
Three, four, or more S-Series enclosures may be flown by purchasing additional Vertical Fly
Kits; two kits will fly three enclosures, three kits will fly four enclosures, and so on.
All parts in the kit are engineered to provide a high margin of safety when used with S-
Series loudspeakers. The brackets are manufactured of steel and covered with a durable
powder-coat finish.
No hardware is provided to attach suspension cables to the Vertical Fly Kit. Such hardware
must be supplied by the installer, and should be rated for the weight load of the enclosures.
The installer is solely responsible for determining if all rigging components that are used to
suspend the enclosures are adequately sized and rated, and if the structure they are
suspended from is capable of safely supporting the aggregate weight load.