Installation manual

Community S-Series - Operation and Installation Manual - Page 52
Figure 17: Never Reeve Cables!
Using More Than One VFKIT
More than one Vertical Fly Kit may be used to fly three, four, or more loudspeakers in an
array. Simply attach the additional kit(s) to the additional enclosures in the same manner
as the first kit.
WARNING: When assembling more than two enclosures into an array, it is very important
that the suspension cables be installed correctly so as not to place undue stress on either
the Vertical Fly Kit or on the enclosures themselves. The following rigging guidelines must
be observed explicitly:
Rigging Three Enclosures
When three enclosures are flown, both of the front and both of the rear hang points
must be used. In other words, two suspension cables or slings must attach to the front
hang points and two cables or slings must attach to the rear hang points, forming two low-
angle bridles as shown in Figure 18 below. Note that every enclosure has at least two live
hang points attached to it.
Figure 18: Rigging Three Enclosures with the VFKIT