Owners manual

47
NAV
The next operating mode is
NAV.
If you
have a GPS, Loran or other navigation
computer interfaced to the autopilot,
program in a waypoint, tell the computer
to begin navigating towards the waypoint
from the vessel's present position, and
turn the autopilot master select switch to
NAV
.
IF YOUR INTERFACE IS USING NMEA
0183 DATA FORMAT
,
(to see which
type of data the autopilot is using to
navigate, press the
TURN
key),
the first
thing that should happen is that the
course display on the autopilot will begin
to change towards the Heading to the
Waypoint as indicated by the Nav
Device.
The autopilot will then further alter its
course to keep the Cross Track Error as
indicated by the Nav Device to a
minimum. If you are in any doubt as to
whether things are working correctly,
WATCH THE CROSS TRACK ERROR.
To change the cross track error response
press
TURN
key followed by the green
ARROW
key.
If it is being maintained at a low value
(i.e. less than 0.02 nautical miles),
everything is working.
If the vessel is wandering back and forth,
but there are no alarms on the autopilot
or Nav Device, the most common cause,
(particularly with Loran), is poor signal
quality. This may be attributed to either:
- poor or no grounding of the Loran,
- noisy alternators on the vessel, or,
- poor antenna location.
Refer to the Nav Device manual for
signal quality displays and ideas on
making improvements. If the Nav Device
is set for automatic waypoint sequencing,
the heading to steer will change when
the next waypoint is selected. The
autopilot will then turn the vessel to the
new course.
IF YOUR INTERFACE ONLY OUTPUTS
NMEA 0180 or 0182 FORMAT
, consult
with the factory service personnel to
obtain special software. The 1001
autopilot software only supports NMEA
0183 format.
You can still use the
DODGE
keys to
avoid obstacles in the water. The only
difference is that after you release the
DODGE
keys, the vessel will return to its
original track, rather than its original
course, unless you reset the point of
origin of the track on the Nav Device.
To prevent the autopilot from making
a course change at a bad time, press
and hold both
DODGE
keys to lock
the rudder at dead ahead. (i.e. if you
see an obstacle in the water that the
vessel will avoid if it DOESN'T make
any course changes)
HINTS
If the heading to steer can be in
degrees magnetic or degrees true,
select degrees magnetic and be sure
the variation is entered correctly.
Course changes during automatic
waypoint sequencing will be smoother
if the arrival circle is set to a small
value such as 0.05 nautical miles.
This usually will let the autopilot bring
the vessel directly onto the next track
when the course change is
completed.