Owners manual

48
REMOTE CONTROLS
To use the remote control, leave the
autopilot in the
PILOT
mode when you
go up to the flying bridge. This will leave
the vessel under control. At the flying
bridge, press both pushbuttons on the
remote control and hold them down for
one second until you see the command
point move to the
REM
position.
The remote control is similar to the main
control panel of the autopilot. The remote
has a
DODGE
/
TURN
toggle switch
instead of separate pushbuttons for
these functions.
For a panic turn, hold the toggle switch in
the
DODGE
position and press a
pushbutton while in
PILOT
or
NAV.
To lock the rudder at dead ahead, hold
the toggle switch in the
DODGE
position
without pressing either pushbutton.
Release the toggle switch to return to the
original course.
To initiate a special turn while in
PILOT
,
push the toggle switch to the
TURN
position and release it. Then press either
pushbutton to initiate a U-Turn,
emergency turn, or continuous turn.
To change the type of turn, place the
master select switch on the remote in the
STANDBY
position. Push the toggle
switch to the
TURN
position and release
it. Select the type of turn desired by
pressing and releasing either the red or
green pushbutton.
TO RECALL THE PILOT'S LAST
PROGRAMMED COURSE, hold the
toggle switch in the
DODGE
position
while rotating the master select switch
from
POWER STEER
to
PILOT.
If you have mechanical steering, you can
disengage the clutch on the drive unit
and return to hand steering by selecting
the
STANDBY
mode.
When you want to go back to the main
control unit, leave the remote in the
PILOT
mode so the vessel is under
control. Walk back to the wheelhouse
and press both the red and green
ARROW
keys. Hold them down for one
second until the command point moves
back to the
MASTER
position.