Owners manual

50
REMOTE CONTROLS
COMNAV 101 REMOTE CONTROL
This remote control plugs into the remote
receptacle on the rear of the autopilot.
Control is taken at the remote by
pressing both its pushbuttons for one
second. The command point on all LCD
displays will move to the
REM.1
position.
A display, master select switch,
pushbuttons, and a
DODGE
/
TURN
toggle switch are also included. Its
operation is identical to the operation of
the autopilot except for the toggle switch.
All the points on the display have the
same meanings as on the autopilot
display.
Place the master select switch in the
STANDBY
position. To display the
currently selected type of special turn,
pull the toggle switch to the
TURN
position and release it
To change the currently selected type of
special turn, press either the red or green
pushbutton.
Place the master select switch in the
POWER STEER
position. To move the
rudder port or starboard, the red and
green pushbuttons can be used.
The vessel's rudder angle will be
displayed while the pushbutton is
pressed.
To recall the vessel's last course, hold
the toggle switch in the
DODGE
position
and then rotate the master select switch
from
POWER STEER
to
PILOT
.
Place the master select switch in the
PILOT
position. The autopilot is now
steering the vessel on its current
heading.
or
If the toggle switch was held in the
DODGE
position while the master select
switch was rotated to
PILOT
, the
autopilot will steer the vessel back to its
last course .
Fi
g
ure 10- 101 Remote Control
The Rudder Follower Failed point is
labelled REM.2 on the 101 Remote
Control.