Specifications

ComNav Explorer V1T and V1C Installation & Operation Introduction
Document PN 29010088 V1.1 - 12 -
Safety Notes!
The following important notes must be followed carefully to run the camera and respective accessories such as
keypad controllers etc. The camera and accessories are referred to as ‘Camera system’ hereafter in this document.
♦
The Explorer V1T Thermal imaging camera is designed to be used in conjunction with other navigational aids and
should not be used as the sole or primary navigation device.
♦
Some Thermal Imaging Camera models cannot be exported to certain territories without specific Export
Licenses which must be obtained from the relevant trade and industry bodies prior to exportation. Failure to
observe strict import and export regulations is a serious offense. Ensure the correct licenses are obtained
where necessary. For further information contact your Comnav dealer or Comnav support. Contact details
can be found within this document.
♦
Before installing the camera, please read this manual carefully. During installation follow the instructions indicated in
this manual. Please keep this manual safe for future reference. An up to date copy is available on our website:
www.comnav.com
♦
The installation of the Camera system including this camera and any associated accessories, should be carried out
by qualified service personnel or system installers in accordance with local regulations.
♦
Before powering the camera please check the supply voltage and ensure the power supply is safely isolated using
an appropriately rated fuse or circuit breaker. Verify that the supply power is within acceptable range (See
specifications, page 32).
♦
Please ensure the power, video and data umbilical are stowed safely and that terminations to third party hardware or
extension cables are properly shielded from moisture
♦
Do not operate the camera beyond the specified temperature and humidity limits
♦
To prevent electric shock, never remove the screws or the cover of the camera. There are no user serviceable parts
within the camera housing. Refer to qualified and approved Comnav service personnel for servicing
♦
Never aim the camera at the sun or other extremely bright objects
♦
Do not manually move the camera even when it is not powered