Specifications

ComNav Explorer V1T and V1C Installation & Operation
Document PN 29010088 V1.1 - 21 -
2. Set camera address, communication protocol and baud rate according to the appropriate
tables below (Table 3 & Table 4);
3. Route prewired umbilical cable through mounting plate hole and attach the camera to the
mounting plate;
4. Secure the camera to the mounting plate using the Three (3) screws provided;
5. Position the Camera in its mounting locations and secure the mounting plate using the
Three (3) screws provided;
6. Route the 3 Meter camera umbilical to the camera controller.
7. Connect the Umbilical breakout cable tail to the Camera’s prewired umbilical cable.
Secure cable with threaded connector;
8. Connect extension cables to the breakout tail if required. For a list of available extension
and ordering information, please check the Ordering Information section, pages 34-35;
9. Connect Video cable (BNC Connector) to the input of the video display. An adaptor might be
necessary to make such connection; video is in composite signal format.
Warning: avoid crossing the Data cable with the Power cable
when making electrical connections. Failure to comply may result
in permanent equipment damage.
10. Connect the RS485 Data cable of the Controller Unit to the RS485 cable of the Camera
breakout tail (or extension). Take care to connect Red wire (RS485 A+) to Red and Black
wire (RS485 B-) to Black;
11. Connect the 12VDC power to the camera power connector (2.1mm DC Barrel connector).
Centre pin is +12VDC and outer ring is GND. If the connector is removed, make sure that
the red wire is connected to +12VDC and the white wire to GND.
Note: If the barrel connector is utilized or replaced by another
connector, make sure that it is protected from moisture and that an
environmentally appropriate connector is used.