Operating Instructions and Installation Instructions
ComNav Navigator G2 Installation & Operation Operation
Document PN 29010081 V1.1 - 37 -
Parameter Setup Pages
The SETUP pages allow you to change parameters within the G2 Vector GPS Compass.
Parameters which can be changed include:
• Message Rates
• Smoothing Filter Time Constants
• Sensor Bias values
• Sensor Aid filters
To change a parameter:
• Select the correct SETUP page by toggling the SETUP button until the desired
parameter appears,
• Select the parameter using the UP Arrow and DOWN Arrow buttons
• Start changing the parameter by pressing the FN button
• Change the parameter value by turning the DIAL knob Clockwise or Counter
Clockwise
• Reject the change by pressing the CLR button, or
• Accept the parameter change by pressing the FN button
Figure 21 illustrates the above procedure.
1) Select Item
3) Change Value
2) Start Change
4) Reject Change OR Accept Change
New
Change
Value
Current
Value
Figure 21 - Parameter Setup Page - Button Descriptions
The NMEA sentences and messages rates can be changed using the Port A or Port B NMEA
message rate pages. This page lists each NMEA sentence which can be changed, as well
as the current message rate.
www.busse-yachtshop.de | info@busse-yachtshop.de