Installation Manual

INS_CLFE4+2SMS[POE](C,U)_REV– 10/27/11 PAGE 7TECH SUPPORT: 1.888.678.9427
FIGURE A
Dimensions are for a ComFit module
INSTALLATION CONSIDERATIONS
These units are supplied as Standalone/Rack mounted module. Units
should be installed in dry locations protected from extremes of
temperature and humidity.
WARNING: Unit is to be used with a Listed Class 2 power supply. Although
the units may be mounted inside a ComNet rack the PoE models cannot be
powered from the built-in rack PSU; they must be powered by an external
48-56VDC PSU.
IMPORTANT SAFEGUARDS:
A) Elevated Operating Ambient
- If installed in a closed or multi-unit rack
assembly, the operating ambient temperature of the rack environment
may be greater than room ambient. Therefore, consideration should be
given to installing the equipment in an environment compatible with
the maximum ambient temperature (T
ma
) specified by the manufacturer.
B) Reduced Air Flow - Installation of the equipment in a rack should be such
that the amount of air flow required for safe operation of the equipment
is not compromised.
© 2016 Communication Networks. All Rights Reserved. “ComNet,” the “ComNet Logo,” “CopperLine,” and the “CopperLine Logo” are registered trademarks of Communication Networks.
3 CORPORATE DRIVE
|
DANBURY, CONNECTICUT 06810
|
USA
|
T: 203.796.5300
|
F: 203.796.5303
|
TECH SUPPORT: 1.888.678.9427
|
[e-mail]
8 TURNBERRY PARK ROAD
|
GILDERSOME
|
MORLEY
|
LEEDS, UK LS27 7LE
|
T: [phone]
|
F: [phone]
|
[e-mail]
INSTALLATION AND OPERATION MANUAL CLFE4+2SMS[POE](C,U) SERIES