User Manual

ManualsBrandsComnet ManualsFiber ConverterEthernet to Fiber Converter

INS_CNFE100(X)_REV–

01/04/10

PAGE 1

INSTALLATION AND OPERATION MANUAL

CNFE100(X) Series

10/100 MBPS ETHERNET 2 PORT MEDIA CONVERTER

1 CHANNEL: ELECTRICAL



OPTICAL

The CNFE100(X) converts 10/100 Mbps Fast Ethernet from an electrical signal

to an optical signal and back to an electrical signal. The electrical connection

uses an RJ45 data connector.

Depending on the specific model in use, the optical connector is either a ST or

SC, 1 or 2 Fibers, multimode (M) or singlemode (S), and the unit operates on

either AC/DC or DC only power.

The CNFE100(X) Series standard size units may be directly plugged into

the ComNet Rack (Part C1) or operated as a standalone module. The

CNFE100(X)-M small size units operate as standalone modules only.

See Figures 1 – 7 for complete installation details.

Summary of content (5 pages)

PAGE 1
INSTALLATION AND OPERATION MANUAL CNFE100(X) Series 10/100 MBPS ETHERNET 2 PORT MEDIA CONVERTER 1 CHANNEL: ELECTRICAL  OPTICAL The CNFE100(X) converts 10/100 Mbps Fast Ethernet from an electrical signal to an optical signal and back to an electrical signal. The electrical connection uses an RJ45 data connector. Depending on the specific model in use, the optical connector is either a ST or SC, 1 or 2 Fibers, multimode (M) or singlemode (S), and the unit operates on either AC/DC or DC only power.
PAGE 2
INSTALLATION AND OPERATION MANUAL CNFE100(X) SERIES FIGURE 1 – CNFE100(X) SERIES STANDARD SIZE UNIT MULTIMODE OR SINGLE MODE OPTICAL FIBER BLACK BLACK WITH WHITE STRIPE FIGURE 2 – CNFE100(X) SERIES STANDARD SIZE UNIT FRONT PANEL REAR PANEL NOTE: Remove Electrical Connector for Rack Mount Units TECH SUPPORT: 1.888.678.
PAGE 3
INSTALLATION AND OPERATION MANUAL CNFE100(X) SERIES FIGURE 4 – CNFE100(X) SERIES SMALL SIZE UNIT MULTIMODE OR SINGLE MODE OPTICAL FIBER BLACK BLACK WITH WHITE STRIPE FIGURE 5 – CNFE100(X) SERIES SMALL SIZE UNIT FRONT PANEL TECH SUPPORT: 1.888.678.
PAGE 4
FIGURE 6 – POSSIBLE ETHERNET CONFIGURATIONS Ethernet IEEE 802.3 Network Element determined by user. SINGLE FIBER Optical Fiber ST Connectors CAT5e/6 with CAT5e/6 with RJ45 Connections Ethernet IEEE 802.3 RJ45 Connections CNFE1002M1A CNFE1002M1B Ethernet IEEE 802.3 Network Element Network Element TWO FIBER Optical Fibers SC Connectors CAT5e/6 with CAT5e/6 with RJ45 Connections Ethernet IEEE 802.3 RJ45 Connections CNFE1003M2A Network Element CNFE1003M2B Ethernet IEEE 802.
PAGE 5
MECHANICAL INSTALLATION INSTRUCTIONS INSTALLATION CONSIDERATIONS This fiber-optic link is supplied as a Standalone/Rack module. Units should be installed in dry locations protected from extremes of temperature and humidity. FIGURE A Dimensions are for a standard ComNet™ one slot module STANDALONE MODULE: The unit is provided with a mounting plate with holes for two No. 6 pan head screws (3 mm or 3.55 mm). Attach the module to a solid piece of wood using two No.