Data Sheet

FEATURES
› Optional 30W or 60W PoE+ on ports 1 and 2
› 10/100 Mbps Ethernet
• 2 × 10/100 BASE-T/TX electrical ports
• 100 BASE-FX optical port
› Electrical ports support Auto-Negotiation for 10 Mbps or
100 Mbps, full duplex or half duplex data.
› Optical port supports 100 Mbps full duplex data
› Automatic MDI/MDI-X crossover
› Distances up to: 3 km (2 mi) Multimode
20 km (12 mi) Single Mode
› Link Fault Pass-Through feature detects if either of the
copper ports are down and triggers the optical port to
switch states to indicate the failure to the head-end.
› Designed to meet full compliance with the environmental
requirements (ambient operating temperature, mechanical
shock, vibration, humidity with condensation, high-line/lowline
voltage conditions and transient voltage protection) of NEMA
TS-1/TS-2 and the Caltrans Specification for Traffic Signal
Control Equipment.
› ST or SC optical connectors
› 1 or 2 fiber design
› Voltage transient protection on all power and signal input/
output lines provides protection from power surges and
other voltage transient events.
› No in-field optical adjustments required
› Full size units feature a contact closure output for remote
side link failure detection
› Standard size is hot-swappable rack module
› Standard size is interchangeable between stand-alone or
rack mount use – ComFit
› IEEE 802.3 compliant
› Lifetime Warranty
APPLICATIONS
› Optical transmission of Ethernet-compatible industrial
security access control systems, intercom systems, VOIP
(Voice over IP) telephony networks, and IP-compatible CCTV
camera surveillance networks
› Optical Ethernet transmission to wireless LAN access points
› Optical transmission of any Ethernet-compatible equipment
with a maximum data rate of 100 Mbps
The ComNet Ethernet CNFE200X media converter series are two-channel Ethernet
electrical to optical media converters with optional PoE+. These auto-negotiating
devices accept two 10/100 Mbps electrical inputs and convert this to a single 100
Mbps optical output. This series of media converters are available as multimode
or single-mode and one and two fiber SC and ST optical connectors. The ComNet
exclusive Demux feature allows for port isolation, replicating two media converters
over one fiber. The ComNet exclusive Mux feature prevents network video flooding
of multicast traffic with DIP switch selection of the fiber port as a dedicated uplink
path. The CNFE200(X) series can be powered by wide range AC or DC input while
the CNFE200(X)POE units meet the 802.3at standard and provide 30 watts of PoE+
power, with an option for a 60 watt CNFE200(X)POEHO model. The PoE models
can be powered by a sold seperately 48 to 56 volt DC power supply.
CNFE200(X)(M,S)(1,2)[POE][HO][/M] Series
2 Channel 10/100 Mbps Ethernet Electrical To Optical
Media Converter with Optional Power over Ethernet (PoE+)
CONVERTER 2HARDENED
803.2at 803.2at
LIFETIME WARRANTY WWW.COMNET.NET TECH SUPPORT: 1.888.678.9427